19
Revision date: 02.16.23
111628E
String Line
Outer Rail
Middle Support Arm
Middle Support Arm
String line will touch the
top of the 2-Way Fitting
at each end.
See photo below for
close up of this fitting.
Assembly Instructions — Level Middle Support Arms
1
Complete these steps to install the additional Tek screws:
1. After the frame is assembled, stretch and tie a string line from
end-to-end along the top of one outer rail. Verify that the string
line is flat against the 2-way fitting at each end.
2. Move to the middle support arm and check the distance
between the string line and the top of the 2-way fitting.
NOTE:
Photo to the right shows a gap between the string
line and the top of the 2-way fitting indicating that the middle
support arm is not level with the support arms at each end of
the frame.
String Line
Outer Rail
To ensure that all support arms are level, complete the
procedure below. Failing to complete this procedure may cause
the center support arm to drop below the level of the support
arms at each end. Uneven water distribution and water flow in
the fodder channels may result.
NOTE:
Actual frame may differ from what is shown. Procedure is
the same however.
