88
111628E
Revision date: 02.16.23
Assembly Instructions
1
ASSEMBLE MAIN FRAME: Base Tubes with Adjustable Levelers
Consult the Quick Start section of this guide for an overview of the system and
additional diagrams. Gather the parts and complete the steps that follow to
assemble the two end frames.
Required parts for
base tubes and levelers
:
• (3) 104626 3-Way Connectors
• (2) 111763A Square Tube (drilled) for end base rails
• (1) 111763B Square Tube (drilled) for mid base rail
• (12) 112502 carriage bolts, (24) FAME09B flat washers, & (24) FALB08B nuts
• FA4482B Tek Screws and Magnetic Nut Setter (3/8" x 2-9/16")
ATTENTION:
Install Tek screws as shown for best results and a uniform appearance.
Review all diagrams for clarification.
Complete these steps:
1. Take the carriage bolts, nuts, and flat washers and assemble as shown in Figure 1.
2. Assemble the two end base rails and the mid base rail as shown in Figure 2. The 3-way connector should be loose between the levelers at this time.
3. Locate the center of each 3-way connector and mark with a pencil or marker.
4. Align the center mark on each connector with the center of the base rail and secure the connector to the base rail as shown in Figure 3.
5. Continue by installing the vertical frame tubes.
FIGURE 1:
Assemble levelers as shown.
FIGURE 2:
Assemble base rails as shown. The 3-way connector
is loose at this point. Levelers should be finger-tight to allow for
adjustments once the system is assembled and in position.
111763B
104626
3-Way
Connector
111763A
111763A
FIGURE 3:
Center the connector
on the base rail
and
secure using two (2) FA4482B Tek screws.
Mark the center
of connector.
FA4482B Tek
Screw
