24
24
111628E
Revision date: 02.16.23
3
ASSEMBLE THE DRAIN MANIFOLD
Required parts:
• 111560 2" PVC Pipe, WF6717 Slip Caps, and 111696
Double Hub (Cross Fitting)
• 111906 1" Sammys and 111907 Conduit Hangers
• FAK26 Threaded Rods and FALB04B Nuts
• 113372 PVC Primer and WF6990 PVC Cement
Assembly Instructions
Complete these steps:
1. Cut 14 horizontal tubes at 33" each. Use the 2" (111560) PVC.
2. Clean the ends of the PVC tubes to remove any loose material.
3. Mark the hole locations on each 33" tube and drill the holes for the drain
elbows of the channels. Use a
1 3/8" hole saw bit
and a drill. (If possible,
drill the holes in the PVC tube using a drill press for accuracy.) Remove
loose material from around the holes and from inside each tube.
4. After cleaning each 33" tube, attach the WF6717 slip cap to the end of the
tube as shown.
DO NOT CEMENT THE CAPS TO THE TUBES. Caps
must remain free for cleaning of the tubes. Set these tubes aside for
later assembly of the drain manifold.
5. Using the 111560 2" PVC pipe, cut six (6) pieces at 14".
6. Take the 111696 cross fittings and 14" tubes and assemble the center
stack of the drain manifold as shown.
Use PVC primer and cement to
attach the vertical 14" tubes to the cross fittings.
Assemble on a flat
surface for best results and to keep the fittings aligned.
14"
14"
14"
14"
14"
14"
111696
Cross Fitting
111696
Cross Fitting
TOP
BOTTOM
DRAIN MANIFOLD –
CENTER STACK
STEP 3
33"
8"
10 1/2"
10 1/2"
Center
Line
8"
WF6717 Slip Cap
(Do not cement.)
NOTE:
Cement all
14" PVC sections
to the 111696
Cross Fittings.