Farm King 482, Operator And Parts Manual

Page: 30 / 102

Assembly - 482 Grain Cleaner
26
Front Guards
Attach the intake pan (Item 1) to the underside of
the front frame weldment using 3/8” x 1” hex bolts,
3/8” flat washers, and 3/8” lock nuts
[Figure 7] .
Position the front pulley guard (Item 2) over the
pulley assembly. Attach pulley guard to the front
frame mounts using 5/16” x 3/4” hex bolts, 5/16”
flat washers, and 5/16” lock nuts
[Figure 7] .
Attach the safety chain (Item 3) to the hitch using
a 3/4” x 5” hex bolt, 3/4” flat washers, and a 3/4”
lock nut
[Figure 7] .
Rear Guards
Position the discharge pan weldment (Item 4) within
the rear frame. Attach the top of the weldment
to the frame using 1/4” x 3/4” self taping screws
(Item 5) and 5/16” flat washers. Attach the sides of
the weldment to the frame using 5/16” x 3/4” hex
bolts (Item 6), 5/16” flat washers, and 5/16” lock
nuts
[Figure 7].
Position the discharge chute (Item 7) on the
discharge pan weldment (Item 4). Attach the top
end of chute to weldment using 1/4” x 3/4” hex
bolts and 1/4” lock nuts. Attach the bottom end of
the chute to the rear frame using 1/4” x 3/4” hex
bolts and 1/4” lock nuts
[Figure 7] .
Position the rear drum shield weldment (Item 8) on
top of the rear frame. Attach the weldment to the
rear frame using 1/4” x 3/4” self taping screws (Item
9) and 5/16” flat washers. Attach the brackets using
3/8” x 1” hex bolts (Item 10), 3/8” flat washers, and
3/8” lock nuts.
Attach the sides of the weldments using 1/4” x 3/4”
hex bolts (Item 11) and 1/4” lock nuts
[Figure 7] .
Attach the intake auger support (Item 12) to the
right side of the rear frame. Attach using 3/8” x
1” hex bolts, 3/8” flat washers, and 3/8” lock nuts.
Attach one half clamp (Item 13) using 3/8” x 1-1/4”
hex bolt, washer, and wing nut
[Figure 7] .