Farm King 482, Operator And Parts Manual

Page: 26 / 102

Assembly - 482 Grain Cleaner
22
Frame And Wheels
Position the front and rear frame weldments (Item
1, 2) with the right and left frame sides (Item 3,
4). Attach using 1/2” x 1-1/4” hex bolts and 1/2”
lock nuts. Frame ends and sides must be squared
before tightening bolts
[Figure 5] .
Position wheels (Item 5) on the axle / hub assembly
(Item 6). Attach using 1/2” x 1-1/4” wheel bolts.
Torque wheel bolts to 80 ft.-lbs.
[Figure 5] .
Lift the frame using an adequate hoist. Position
axle and wheel assembly under the frame.
Position the axle braces (Item 7, 8) between the
frame sides and axle. Attach axle braces using 1/2”
x 1-1/4” hex bolts and 1/2” lock nuts
[Figure 5] .
Position the center axle braces (Item 9) between
the frame sides and axle. Attach axle braces using
1/2” x 1-1/4” hex bolts, 1/2” flat washers, and 1/2”
lock nuts
[Figure 5] .
Position the frame braces (Item 10) between
the front axle braces (Item 7) and front frame
weldment (Item 1). Attach frame braces using 1/2”
x 1-1/2” hex bolts, 1/2” flat washers, and 1/2” lock
nuts
[Figure 5] .
Attach hitch weldment (Item 11) to the frame using
1/2” x 1-1/4” hex bolts, 1/2” flat washers, and 1/2”
lock nuts
[Figure 5] .
Attach the left and right hitch braces (Item 12, 13)
between the hitch weldment and front frame using
3/8” x 1-1/4” hex bolts, 3/8” flat washers, and 3/8”
lock nuts
[Figure 5] .
IMPORTANT
All bolts connecting the frame must be firmly
tightened to proper torque. Any loose bolts could
result in the frame separating while towing the
cleaner.
Slide the support stands (Item 14) into the front
frame weldment mounts. Secure using stand pin
and clip
[Figure 5] .
Attach the manual holder (Item 15) to the top of the
front frame weldment using 5/16” x 1” hex bolts
and 5/16” lock nuts
[Figure 5] .
Connect the jack stand (Item 16) to the hitch
weldment
[Figure 5] .
Attach the trash chute mount (Item 17) to the rear
frame weldment using 5/16” x 3/4” hex bolt and
5/16” lock nut
[Figure 5] .
Attach one pillow bearing (Item 18) to the top of
the rear frame weldment using 1/2” x 1-3/4” hex
bolts, 1/2” flat washers, and 1/2” lock nuts
[Figure
5] .
Attach one pillow bearing (Item 19) to the underside
of the front frame weldment using 1/2” x 1-3/4” hex
bolts, 1/2” flat washers, and 1/2” lock nuts
[Figure
5] .