Navigation
User Manual Falk Navigator
- 34 -
formulated location description will be displayed for you. All you need to do is read where you
are located.
If you are on a highway or main road, no address is displayed but rather the road number,
such as A8 or B191.
In addition to your position information, you will find additional important information by
tapping on the following icons:
Information
on
emergency call numbers
Reference
to
hospitals
in the area
Reference
to
petrol stations
in the area
In the menu bar below, you can also display the location via the geo-coordinates (
GPS
Info
), and you will find under
Country info
important information on the traffic regulations
and laws applicable in the country where you are currently located.
Notes:
The map material for the country where you are currently located must already be
installed on your navigation device in order for the navigator to find your current position
and to display the information described above.
In some areas with no GPS or inadequate GPS reception, such as in tunnels, garages,
underpasses etc., it might not be possible under certain circumstances to determine your
current GPS position with the aid of your mobile navigation device. Therefore, in these
situations it is not possible to execute the "My location" function or this will only be
available to a limited extent.
United Navigation GmbH cannot assume any responsibility for the accuracy or
completeness of the corresponding information. No liability shall be assumed for
damages of any kind whatsoever as a result of using the information retrieved!
2.2.3 Block road (optional!)
With the Block road function you can block a road section permanently so that your
navigation device calculates a detour in the event of a traffic obstruction. The block you have
entered can be displayed on the
map
and removed again from the list using the
Delete
block
button.
Press the Block road button. A map of the
surrounding area of your location is displayed.
Tap on the map to define a start and end
point of the section you want to block. The
points will be marked with the letters A and B.
Confirm with
OK
.
Specify the direction in which the section
should be blocked (from A to B, from B to A or
in both directions). Confirm with
OK
.
