10.2 Shuttle heater resistor replacement.
To replace this resistor, proceed as follows:
- Turn off the machine using the MAIN SWITCH and disconnect the machine cable from the
electricity supply
- Eliminate the blocking effect produced by the sphere and spring wheat M6x15 cod. 90702.5
- Remove the heater resistor and diconnect the wire from the terminal (faston).
Once the operation is completed, the operator will find himself with the resistance and electrical wire in
hand.
To assemble a new resistor, carry out the procedure described above, but in reverse order.
Warning:
Given the high temperature of the resistor when the machine is running, thermal gloves and tweezers are
advice for extraction.
Drawing 23
Wheat
Shuttle heater resistor
Generated by Foxit PDF Creator © Foxit Software
http://www.foxitsoftware.com For evaluation only.
