Pellets Stove
12
12
12
12
stoke pellets and the resistance will keep warming up. When the temperature is high enough, thanks to the
fume gas feeler, the electronic gear case (after 7-10 minutes) will consider the starting phase ended and start
the next phase of flame stabilisation displaying “FirE on” and starting the tangential ventilator (heat
exchanger). When the “FirE on” phase ends, the gear case will set the work state, displaying the chosen
heating power (you can change it with keys P6 and P5) and the environment temperature. During this phase
keys P5 and P6 can regulate the stove power from 1 to 5. If the environment temperature exceed the limit
parameter fixed on key-board during the temperature setting the heating power will decrease to minimum
rate until the parameter is back to its prefixed limit and the display will show “RiS”.
Non
Non
Non
Non----starting
starting
starting
starting
If pellets don’t light up, the non-starting will be indicated by an alarm “AlAr no FirE”. The stove starting takes
about 7/10 minutes with good quality pellets and an environment temperature of about 10°C. If the
environment temperature is lower, the starting plug is not able to start the stove; in this case you can help
putting a lighted igniter on the brazier.
Energy failure
Energy failure
Energy failure
Energy failure
After an energy blackout, when the stove is restored it will display “AlAr no rEtE”. The fumes gas extractor
will discharge the fumes residuals for 20 minutes starting the switching off phase. When the cooling phase is
completed, empty the brazier from excessive pellets and start the stove again.
To bypass the start stage (e.g. the fire goes out unintentionally): just press key (6) for about 2 sec. and the
stove will immediately go into the ON operating phase; it is only possible to jump the startup phase if the
smoke temperature (detected by the probe) is over 55°-60°C. Below these values, after several seconds the
stove will return to the “Fan Cand” startup stage.
Temperature setting
Temperature setting
Temperature setting
Temperature setting
To modify the environment temperature you can press any time key P3 together with P1 or P2 to regulate it.
The chosen temperature and the environment temperature will be displayed on display b.
Fumes gas temperature
Fumes gas temperature
Fumes gas temperature
Fumes gas temperature
To verify the fumes gas temperature at the outlet keep key P1 pressed for few seconds.
Switching off
Switching off
Switching off
Switching off
To switch off the stove keep P4 pressed, “OFF” will be displayed on display a. During this phase the stoking
of pellets is stopped, the tangential fan is switched off and after 20 minutes the fumes extractor is turned off
too (that occurs anyway if the stove is hot or cold).
To put off the fire
To put off the fire
To put off the fire
To put off the fire
If it happens you suddenly have to put off the fire burst out from the stove or chimney flue, use carbon dioxide
extinguisher (CO2) or ask for the fire-brigade intervention. Do not use water to put off the fire in the brazier.
Pellets stoking
Pellets stoking
Pellets stoking
Pellets stoking
If you have to stoke the stove with pellets while it is working, make sure the pellets bag doesn’t get in contact
with any hot surface. Make sure the pellets tank is always closed with its lid. Don’t put any residuals of
combustible material (unburned embers) of the brazier into the pellets tank.
Clock setting
Clock setting
Clock setting
Clock setting
To set the clock press key P3 some times until the green led with the clock lights up and “UT02” is displayed,
then you can regulate time with keys P1 and P2.