Pellets Stove
14
14
14
14
The remote control operates with a 12 Volt MN21 type battery.
The batteries should be removed from the device before it is disposed of and must
themselves be disposed of safely.
Carry out the following operations to change the batteries:
- use a screwdriver to loosen the screw on the back of the remote control;
- slide out the cover and replace the batteries, taking care to orient the polarities
correctly;
- close the cover and tighten the screw.
•
SAFETY DEVICES
SAFETY DEVICES
SAFETY DEVICES
SAFETY DEVICES
Introduction
Introduction
Introduction
Introduction
Pic. 12
Safety devices are useful to prevent and avoid risks of damages to people, pets or property. You should
avoid to tamper with them or cal non-authorised staff to have them repair, making the guarantee not valid and
the manufacturer not responsible for them.
Pressure switch alarm
Pressure switch alarm
Pressure switch alarm
Pressure switch alarm
A pressure switch is connected to the boiler pipeline to check the depression. If “AlAr dEP” appears on
display the pressure switch stops the electric input to the cochlea blocking the pellets stoking to the brazier
and starting the switching off phase. The electronic card makes the fumes extractor work at maximum speed
and then turns it off within 20 minutes. Switch the stove off with ON/OFF key. Verify the occurring fault on
page 20. After detecting the cause of the fault, clean up the brazier and restart the stove with ON/OFF.
Ther
Ther
Ther
Thermocouple fumes feeler alarm
mocouple fumes feeler alarm
mocouple fumes feeler alarm
mocouple fumes feeler alarm
A feeler, which controls constantly the temperature, is connected to the fumes waste duct. When the feeler is
damaged or disconnected “AlAr Sond” will appear on display. The electronic card stops the electric input to
the cochlea blocking the pellets stoking to the brazier and starting the switching off phase. The electronic
card keeps the fumes extractor working for 20 minutes to cool the stove down. Let the stove cool down, and
then switch it off with ON/OFF. Verify the occurring problem on page 20. After solving the problem clean up
the brazier and start the stove with ON/OFF.
Alarm of non
Alarm of non
Alarm of non
Alarm of non----starting
starting
starting
starting
The fumes thermocouple takes control of the stove in case of non-starting when the temperature is not high
enough to allow the starting. When “AlAr no FirE” appears on display the feeler through the electronic card
starts the turning off phase after 20 minutes. Verify the occurring problem on page 20. After solving the
problem clean up the brazier and start the stove with ON/OFF.
Over
Over
Over
Over----heating alarm
heating alarm
heating alarm
heating alarm
If the fumes feeler detects a temperature higher than 200°C at the fumes waste duct, “RiS” will appear on
display, the pellets stoking is decreased and the card makes the fumes extractor work at its maximum speed
to take the temperature back to the set limits. If temperature shouldn’t decrease but increase up to 215°C the
stave starts the switching off phase. Verify the occurring problem on page 20. After solving the problem clean
up the brazier and start the stove with ON/OFF.
Switchi
Switchi
Switchi
Switching off alarm
ng off alarm
ng off alarm
ng off alarm
If the fumes feeler detects a temperature lower than the minimum limit, “AlAr no FirE” will appear on display.
That means the fire went out and the electronic card starts the switching off phase. Verify the occurring
problem on page 20. After solving the problem clean up the brazier and start the stove with ON/OFF.
