FAIR S7, Maintenance And Use Manual

Page: 20 / 28

Pellets Stove
20 20 20 20
•
IF THERE IS A PROBLEM IF THERE IS A PROBLEM IF THERE IS A PROBLEM IF THERE IS A PROBLEM
Problem Problem Problem Problem Cause Cause Cause Cause Solution Solution Solution Solution
• The control panel
doesn’t start
• The stove hasn’t got electrical input
• Card protection fuse is burned
•
Control panel is faulty
• Flat cable is faulty
• Electronic card is faulty
• Verify if the plug is connected
• Replace the fuse. Call a specialised
technician
•
Replace the control panel
cod.Com0241. Call a specialised
technician
•
Replace the flat cable
cod.Com0240. Call a specialised
technician
• Replace the electronic card
cod.Com0231. Call a specialised
technician
•
The stove doesn’t start.
Alarm displayed: “AlAr
no FirE”
•
The tank is empty
• The brazier isn’t cleaned
• The feeler hasn’t detected the
minimum threshold to start
•
Starting plug is faulty
•
Outside temperature is too cold
• Pellets are wet
• Thermal feeler is blocked
•
Electronic card is faulty
•
Fill the tank
• Clean the brazier (see Maintenance)
• Empty the brazier and start again, if
the problem continues call a
specialised technician
•
Replace the plug, cod Com0234.
Call a specialised technician
•
Restart the stove
• Pellets must be stored in a dry room.
Verify
• Replace the feeler, cod Com0139.
Call a specialised technician
• Replace the card, cod Com0231.
Call a specialised technician
• Pellets don’t get to the
fire box
• The tank is empty
•
Cochlea is blocked by a strange object
(ex. Nails)
•
Cochlea gear motor is damaged
• Verify if there is an alarm activated on
display (ex. AlAr dEP., AlAr Sic…..)
• Fill the tank
•
Unplug the plug, move the inside
hand protection of the tank, empty
the tank, clean the cochlea e start
again
•
Replace the gear motor, cod
Com0232. Call a specialised
technician
• Call a specialised technician to
check the stove and detect the
problem
•
The fire goes out and
the stove stops
•
The tank is empty
• Cochlea is blocked by a strange object
(ex. Nails)
• Pellets aren’t of good quality
•
The phase 1 parameter set in the
electronic card is too low
•
Verify if there is an alarm activated on
display (ex. AlAr dEP, AlAr Sic…..)
•
Fill the tank
• Unplug the plug, move the inside
hand protection of the tank, empty
the tank, clean the cochlea e start
again
• Try different types of pellets
•
The pellets supply must be regulated
by a specialised technician
•
Call a specialised technician to
check the stove and detect the
problem
•
The fire has a weak
and orange flame,
pellets don’t burn
correctly and the glass
gets black
•
The air for combustion isn’t enough
•
The waste pipe is blocked
• The stove is obstructed
• Fumes extractor is damaged
•
Check the following: possible
obstructions of the air inlet on the
back of the stove: brazier grid holes
obstructed and/or brazier box with
too much hash: exchanger pipes too
dirty; clean the extractor blades and
its scroll (see Maintenance)
•
Exhaust chimney is partially or
totally obstructed (call an expert