FAIR S7 Maintenance And Use Manual Download Page 15

Page: 15 / 28

Pellets Stove

Energy black out alarm

After an energy black out “AlAr no rEtE” will appear on display. The fumes extractor will clear up the fumes
residuals for 20 minutes starting the switching off phase. When cooled down, verify the occurring problem on
page 20. After solving the problem clean up the brazier and start the stove with ON/OFF.

Tank safety alarm

There is a manual winding thermostat near the tank, which controls if the temperature exceeds the allowed
limits preventing in this way the pellets from catching fire because of the over-heating. “AlAr Sic” will appear
on display and the thermostat stops the electrical input to the cochlea blocking the pellets stoking of the
brazier and starting the switching off phase. Let the stove cool down and then switch it off with ON/OFF.
Verify the occurring problem on page 20. After solving the problem wind the thermostat: unscrew the black
cap, press the black button and screw the cap back. Clean up the brazier and restart the stove with ON/OFF.

•

MAINTENANCE

Introduction

To extend the life of your stove it is important to clean it periodically as indicated hereafter. It is also
necessary to have an extraordinary maintenance intervention done on the stove and chimney once a year
calling the assistance service on time. Do not use steel-wool, muriatic acid or corrosive and scratching
products to clean its inner and exterior parts. In case of damages always use original spare parts asking to
authorised shops or to the manufacturer.
Important: before cleaning or performing maintenance let the fire go out completely and the stove cool down
and disconnect it from electrical power supply.

Filter cleaning

The stove is equipped with a filter against dust, which is placed on the air ventilation duct on the stove back
and must be cleaned once a month. Take the filter out and wash it without water.

Majolica parts cleaning

We would like to remind you that the majolica parts are craft-made and therefore they can have little flaws
(flaws interlacing due to thermal dilation between the biscuit and the paint), marking by tricks (very little holes
due to microscopic gas blisters that appear on surface during the cooking) shadings (shades of paint due to
concentration of colour in particular areas of majolica). To clean the majolica parts you should use a dry and
soft cloth. If you use any kind of detergent that will filter through the flaws showing them up.

Painted metal parts cleaning

Use a wet soft cloth to clean the painted metal parts. Do not use degreasing substances, alcohol, diluent,
acetone, petrol that can damage irreparably the paint.

Glass cleaning

The fire-door pyroceram resists to 700°C but not to sudden changes of temperature. Therefore you can clean
the glass with normal glass products but you have to wait for the glass to cool down to avoid its explosion. If
you break the glass you must replace it before using the stove.

Fumes ducts cleaning

Using brushes clean the soot from: the fume duct, the chimney flue and the chimney pot. A specialised
technician should carry out this cleaning and verify its effectiveness.

Fumes chamber cleaning

Every two weeks it is recommended to clean the fumes chamber.