Pellets Stove
11
11
11
11
Introduction
Introduction
Introduction
Introduction
It is recommended to follow the hereunder guidelines for the best functioning and least consumption. If the
installation is well carried out and the fumes pipe is efficient the lightning of the pellets will be very easy. The
procedure is as following: empty and clean the brazier, verify there are enough pellets in the tank. If you start
the stove for the first time you should wait for the cochlea to be filled with pellets and that requires at least
three attempts at starting, as the brazier is empty. Make sure the door is well close.
Important: don’t use any kind of inflammable liquid during the lightning (alcohol, petrol, gasoline, etc.).
Important: at the first starting you should keep the fire lightning slowly for at least 24 hours to allow the
materials the stove and the furnace are made of to settle the inner elastic stress avoiding permanent
damages. Some greasy working residuals and paints can produce smell and smoke during the first hours of
functioning, we recommend to air the room as they can be harmful to people and pets.
Important: the programming parameters from 1 to 5 are set by the company and can be changed only by an
authorised technician.
Pic. 11
Control panel
Control panel
Control panel
Control panel
Key P1 and P2: when you are setting the temperature they increase or decrease the thermostat parameter
from minimum 06°C to maximum 41°C. If you keep P1 pressed you can see the waste fumes temperature
displayed. They both have programming function.
Key P3: to go to temperature and menu of parameters of the user and technician.
Key P4: (ON-OFF) to turn on and off, to unlock from alarms and go out from programming
Key P5 and P6: to increase or decrease the heating power from 1 to 5:
Led 1: active time programming
Led 2: if it is on the cochlea is activated
Led 3: to receive input from the remote control
Led 4: to turn on the thermostat
Led 5: it flashes when you are setting temperature or you are inside menu
Display A: during starting it shows the card state, during functioning it shows the heating power, when setting
input it shows the parameter label you are changing.
Display B: during starting it shows the card state, during functioning it shows the temperature chosen by the
user, during setting of inputs it shows the parameter you are changing.
Starting
Starting
Starting
Starting
To start the stove, keep key P4 pressed for few seconds, then the gear case will set the stove in a pre-
ventilation state, displaying “Fan Cand”, starting the extractor fan at minimum rate and the pre-heating of the
starting resistance. After this phase which lasts 2 minutes, it will be displayed “Load Wood”, the cochlea will
