PACKING
Packing
The packing includes a cardboard box, which is recyclable in accordance with RESY guidelines, some
recyclable inserts made of expanded EPS and wooden pallet. All package materials can be used again
for similar use or taken away as solid urban waste in accordance with the regulation in force.
After you have taken the package away make sure the appliance is in perfect conditions.
IMPORTANT!
we recommend you move the appliance with adequate means paying attention to the safety regulation.
Don’t turn the package upside down and handle the majolica details with care.
CHIMNEY FLUE
Introduction
This chapter gives you some directions for a good and correct fulfilment of the chimney flue but it doesn’t
replace the regulations in force that a qualified chimney setter should know.
The company declines any responsibility for the bad functioning of the stove if that is caused by a bad
dimensioned chimney flue that is not in accordance with the regulation in force UNI10683.
Chimney flue
The chimney flue or chimney has a great importance for a heating appliance which uses solid
combustible materials of b type with forced draft; as modern heating appliances are high efficient with
colder fumes and a consequent lower draft it is really important that the chimney flue is properly built
and always maintained perfectly efficient. The flue can be single (UNI7129 / 92 standard), or insulated
directly to the outside with roof drain (UNI7129 / 92 standard) (see picture 1 a and b) It is not possible
to connect more than one pellets appliance to the same chimney flue.
Pic. 1
Technical characteristics
The chimney flue must be fume tight (a seepage of air through cracks or an inspection door which isn’t
fume tight will highly reduce the draught of the chimney). It must be vertical without obstructions, made
of materials that are impermeable to fumes and condensate, thermal insulated and adequate to be
resistant against normal mechanical stress on a long term (we recommend chimneys made of a/316 or
refractory material with double insulated chamber of round section). It must be insulated from the