![background image](http://html1.mh-extra.com/html/fair/h18/h18_maintenance-and-user-manual_3196761023.webp)
SAFETY DEVICES
Introduction
Safety devices are useful to prevent and avoid risks of damages to people, pets or property. You should
avoid to tamper with them or to call unauthorised staff to have them repaired, making the guarantee not
valid and the manufacturer not responsible for them.
For more details on the possible causes and solutions go to the table on page 31.
Alarm 1 - Energy black out alarm
After an energy black out, when power is resorted, “BLACK OUT” will appear on
display. The fumes extractor will clear up the residual fumes for 20 minutes
starting the shutdown phase.
Let the stove cool down, and then switch it off with the 4 ON/OFF key. Verify the occurring fault on page
31. After detecting the cause of the fault, clean up the brazier and restart the stove with the ON/OFF
button.
Alarm 2 - Fumes feeler alarm
A feeler, which controls constantly the temperature, is connected to the fumes
waste duct. When the feeler is damaged or disconnected “PROBE EXHAUST”
will appear on display. The electronic card stops the electric input to the cochlea
blocking the pellets stoking to the brazier and starting the shutdown phase The
electronic card keeps the fumes extractor working for 20 minutes to cool the stove
down.
Let the stove cool down, and then switch it off with the 4 ON/OFF key. Verify the occurring fault on page
31. After detecting the cause of the fault, clean up the brazier and restart the stove with the ON/OFF
button.
Alarm 3 - Over-heating alarm
If the fumes feeler detects a temperature higher than 230°C at the fumes waste
duct, the pellets stoking is decreased to phase 1. This function brings the
temperature back to the set limits. During this phase on the display will appear
“HOT EXAUST” If for some reason temperature should not decrease but increase
up to 280°C, the stove starts the shutdown phase.
Let the stove cool down, and then switch it off with the 4 ON/OFF key. Verify the occurring fault on page
31. After detecting the cause of the fault, clean up the brazier and restart the stove with the ON/OFF
button.
Alarm 4 – Exhaust fan failure
This alarm appears when the electronic board no longer detects the activity of the
smoke extraction engine. This can result from a fan failure, the failure of the
encoder that detects the revolutions or a damage in the encoder cable.
Allow the stove to cool then turn it off using the 4 ON / OFF button. Check the type of fault as shown on
page 31. After removing the cause, clean the brazier and restart the stove using the ON / OFF key.
AL 1
18.0° 60°
BLACK
OUT
AL 3
00.0° 60°
HOT
EXAUST
21:30
00.0° 60°
PROBE
EXHAUST
AL 4
00.0° 60°
FAN FAIL