Final cleaning is performed and, after the flue temperature detected by the probe drops below a certain
threshold, the flue extractor turns off, thus concluding the stove's shutdown cycle.
Restarting
If the shutdown phase has been started, the stove will not be able to be turned
back on until a safety time has elapsed and the flue temperature drops below a
certain threshold.
When it has cooled off, empty the brazier from the pellet accumulation and begin the start-up phase.
Failure to start
If the pellets do not light up, start-up failure will be signalled by an “NO LIGHTIN-” alarm. The stove
turns on is about 7/10 minutes, if using quality pellets and at a room temperature of approximately 10°C.
If room temperature is lower, the glow plug will not be able to provide the ignition. To help it to light up,
insert a lit igniter in the brazier.
Energy failure
After an energy blackout, when power is restored, the stove will go into the shutdown process unless
the power cut was very brief. In this case, the stove could continue in the suspended phase, for example:
start-up, pellet loading, waiting for the flame, work, brazier cleaning or shutdown.
Flue gas temperature
To verify the flue gas temperature at the outlet, keep key 2 pressed.
Putting out the fire
If it happens you suddenly have to put out the fire burst out from the stove or chimney flue, use a carbon
dioxide (CO
2
) fire extinguisher or ask for the fire-brigade intervention.
Do not use water to put out the fire in the brazier.
Pellets stoking
If you have to stoke the stove with pellets while it is working, make sure the pellets bag doesn’t come
into contact with any hot surface. Make sure the pellets tank is always closed with its lid.
Don’t put any residuals of combustible material (unburned embers) of the brazier into the pellets tank.
Optional remote control
With the remote control it is possible to adjust the heating power, the desired
ambient temperature and switch the apparatus on/off automatically.
To switch on the stove press buttons P1 and P6 simultaneously for 3 seconds;
the apparatus will automatically enter the ignition stage. After the ignition
stage it will enter normal operation mode and buttons P6 and P5 can be used
to adjust the heating power. Pressing P1 or P2 will adjust the desired ambient
temperature. To switch off the stove keep buttons P1 and P6 pressed
simultaneously for 3 seconds, display will show the message “Off”.
The remote control operates with a 12 Volt MN21 type battery.
The batteries should be removed from the device before it is disposed of and
must themselves be disposed of safely.
Carry out the following operations to change the batteries:
- use a screwdriver to loosen the screw on the back of the remote control;
- slide out the cover and replace the batteries, taking care to orient the
polarities correctly;
- close the cover and tighten the screw.
21:20
23.0° 40°
COOLING
WAITING-
Pic.12
