FAAC E124, Rapid Manual

Page: 11 / 24

10
ENGLISH
Display Basic Function
cF
0 1 2 4 3 6 5
M2
MOTOR 2 dead-man DRIVE mode (visualised only with the function
Mn
=
2
)
+
OPENS (visualising
oP
) until the button is held down
-
CLOSES (visualising
cL
) until the button is held down
-- -- -- --
M1
MOTOR 1 dead-man DRIVE mode
+
OPENS (visualising
oP
) until the button is held down
-
CLOSES (visualising
cL
) until the button is held down
-- -- -- --
tL
WORK TIME LEARNING (SETUP):
See the related paragraph.
-- -- -- --
St
AUTOMATED SYSTEM STATUS:
You can exit programming, choosing whether or not to save the configuration you just performed.
1. set the choice:
Y
to SAVE and EXIT the programming
no
to EXIT the programming WITHOUT SAVING
2. press the button F to confirm; at the end the display returns to visualize the automated system status :
Y
00
= CLOSED
01
= OPEN
02
= Stationary then “OPENS”
03
= Stationary then “CLOSES”
04
= In “PAUSE”
05
= during Opening
06
= during Closing
07
= FAIL SAFE in progress
08
= checking BUS-2EASY devices in progress
09
= Pre-flash then “OPENS”
10
= Pre-flash then “CLOSES”
11
= Emergency open
12
= Emergency close
HP
= Hold position
WARNING If power is lost to the board prior to confirmation (step 2.), all changes made will be
lost.
F
+
-
You can EXIT programming at any time: press and hold F and then also
-
to switch directly to
St
.