19
OPEN A
RADIO 1
DL16
P1 + P2
(MASTER)
(MASTER)
(MASTER)
OK
9
RADIO 2
DL17
OPEN B
MAX
5”
2 x 2”
OK
9
(MASTER)
(MASTER)
1”
(MASTER)
x 2
ENGLISH
To enable other radio controls with the same system code, you must transfer the system code of the memorised radio control button to the
button corresponding to the radio control you wish to add:
1. Simultaneously press and hold P1 and P2 on the memorised radio control.
2. The radio control LED will begin to flash.
3. Release both buttons.
4. Press and hold, while the radio control LED is still flashing, the memorised button (the radio control LED will go on steady).
5. Bring the radio controls close together, press and hold the corresponding button of the radio control you wish to add, and release only after
the radio control LED flashes twice, indicating that memorisation has been completed.
6. Press the button of the memorised radio control twice in succession. The automated system will perform an opening cycle.
Ensure that there are no obstacles (by people or things) during the automated system movement.
MEMORISING LC/RC RADIO CONTROLS (433MHz ONLY)
1. Press and hold + (OPEN A programming) or - (OPEN B/CLOSE programming).
2. After keeping the button pressed for about 5 sec, the corresponding radio LED (DL11 or DL12) will begin to flash slowly for about 20 sec.
3. Release the button.
4. During radio LED flashing, press the desired button of the
LC/RC
radio control.
5. The corresponding LED on the board (DL11 or DL12) will go on steady for 1 second, indicating that memorisation has been completed, and
will begin flashing again for another 20 sec during which you can memorise another radio control.
6. When the 20 sec have elapsed, the LED will turn off, indicating that the procedure has been completed.
7. To add other radio controls, repeat the procedure from point
REMOTE MEMORISATION OF
LC/RC
RADIO CONTROLS
With
LC/RC
radio controls you can remotely memorise other radio controls, i.e. without working directly on the board, using a previously me-
morised radio control.
1. Take a radio control that has already been memorised on one of the 2 channels (OPEN A or OPEN B/CLOSE) and move to the vicinity of the
board.
2. Simultaneously press and hold P1 and P2 until both LEDs flash slowly for 5 sec.
3. Within 5 seconds, press the previously memorised radio control button to activate the learning phase for the selected channel.
4. The LED on the board corresponding to the channel in learning mode will flash for 20 sec within which another radio control code is transmitted
by pressing the button.
5. The corresponding LED on the board will go on steady for 2 sec (indicating that memorisation has been completed) and will begin flashing
again for another 20 sec, during which you can memorise other radio controls, and will finally go off.
Summary of Contents for E124
Page 1: ...E124 ...
Page 23: ......
