FAAC E124, Rapid Manual

Page: 7 / 24

6
F
F
-
+
F
F
+
+
F
+
+
ENGLISH
PROGRAMMING
Programming is divided in two levels:
‡ BASIC programming
‡ ADVANCED programming
The programming phases are (see Tab. ):
1. to access PROGRAMMING ( 1A or 1B );
2. to show the set values and modify them, if you want. Changing the values is effective immediately, while the final memorisation must be carried out
upon exiting programming (
St
) .
3. exit the programming by using
St
function. Select
Y
to SAVE the configuration you just performed, otherwise select
no
to EXIT WITHOUT
SAVING any changes.
You can EXIT programming at anytime :
‡ press and hold F and then also
-
to switch directly to
St
.
F
+
-
This board also allows programming using a PC or MAC .
This programming requires connection to PC/MAC via USB cable and USB-B relevant port.
The programming SOFTWARE with relevant instructions, must be downloaded from the website
:
www.faacgroup.com
The programming using a PC/MAC, with the default PASSWORD does not inhibit the programming by board. The writing
PC
will be displayed
in correspondence with the modified values. Notes : when you modify the values by board the previous PC/MAC programming will be overwrote.
The default password is 0000.
The programming using a PC/MAC, with a modified PASSWORD (different from the default one), will inhibit the programming by board. If one
of the buttons is pressed, the display will show
PC
programming for 5 sec and changes will be allowed only by PC /MAC.
쐃 쐇 쐋
BASIC
PROGRAMMING
1A
.
PRESS AND HOLD
F :
THE FIRST FUNCTION APPEARS
Í 1
RELEASE
F :
THE FUNCTION VALUE
IS DISPLAYED
USING
+
OR
-
,
SCROLL THE
AVAILABLE VALUES
UNTIL THE THE
DESIRED ONE
PRESS
F :
TO MOVE TO
THE NEXT
FUNCTION
Í 1
FUNCTION
St
(
LAST BASIC OR ADVANCED
FUNCTION
)
ADV
ANCED
PROGRAMMING
1B .
PRESS AND HOLD
F
AND
THEN ALSO
+
:
THE FIRST FUNCTION APPEARS
Í 1
RELEASE THE KEYS
:
THE FUNCTION VALUE
IS DISPLAYED
SELECT
Y
TO SAVE THE
PROGRAMMING
OTHERWISE
SELECT
no
TO EXIT THE
PROGRAMMING WITHOUT
SAVING
Í 1
THE FUNCTION IS DISPLAYED UNTIL YOU HOLD
Tab. Programming phases.
Connector J13 – XF MODULE rapid connection
The control unit has an integrated 2-channel decoding system (DS, SLH, LC/RC) named OMNIDEC. This sy-
stem makes it possible to save – through an extra receiver module – XF433 or XF868 radio commands of the
same frequency, but of a different type (DS, SLH, LC/RC). It is possible to save both total opening (OPEN A)
and partial opening (OPEN B) of the automated system, up to a maximum of 256 channels.
Insert and remove the boards only after cutting power.