B614 37
732998 - Rev.A
Tr
ansla
tion of the orig
inal instruc
tions
ENGLISH
7. START-UP
RISKS
PERSONAL PROTECTIVE EQUIPMENT
!
During operation there is a risk of cutting, crushing
or the total loss of hands due to the moving parts
inside the box.
If two barriers are installed in the following configu-
ration Master-Slave, before beginning the start up
of the Master, it is necessary to have configured the
Slave barrier (see § 10).
1. Check that the B614 is locked.
2. Power up the plant (
Master
barrier). The board
lights up and the display then comes on:
-
firmware version (2 digits separated by a point)
-
SO
flashing if a set-up or the automation status
is requested
3. Check the status of the LEDs at rest (see § 11.1).
L
i
The BUS 2easy LEDs must be checked after the devices
have been registered.
4. Memorise the radio controls present on the plant
5. Program E614 without performing the set-up.
!
For the barrier to work properly, set the parameter
cF
dependent on the beam length.
6. Register the BUS 2easy devices, if they are installed
7. Check the barrier's direction of travel (see § 11.2).
8. Perform the set-up (see § 7.3).
9. If the XBAT 24 battery is being used:
-
Cut off the plant's power supply
-
Connect the XBAT 24 battery
-
Switch on power to the system.
7.1 PROGRAMMING
BASIC PROGRAMMING
1. Press and hold down
F
until the first basic
function appears. (Each function is displayed
as long as
F
remains pressed).
F
2. Release: the value of the function appears
(default or programmed).
F
3. Use the
+
or
-
button to modify the value.
-
+
4. Press
F
to confirm the value displayed. Go
to the next function. The modified value
becomes effective immediately.
F
Proceed in the same way for all the functions. The last function
(
St
) allows you to close the program.
5. In
St
select
Y
or
no
using the
+
/
-
buttons:
Y
= save the new program
no
= DO NOT save the new program
6. Press
F
to confirm and close the program. It returns to the
automation status view.
To
exit from the programming mode at
any time
:
press and hold down
F
and then
-
as well to
move directly to
St
.
F
+
-
-