4 4
4 5
B614 44
732998 - Rev.A
BUS
BUS
GND
LAMP
OUT 4
OUT 3
OUT 2
OUT 1
+24V
LAMP
PE
N
L
N
L
6 A
OPEN
1
2
3
4
5
6
+24V
GND
EMER
ST
OP
CL
OSE
LOOP 2
LOOP 2
LOOP 1
LOOP 1
XF 433-868
AC MAIN
ENC
TRAFFIC
LAMP
LIGHT
BEAM
COM
BLR
BLG
MOT
MOT
M
J16
Tr
ansla
tion of the orig
inal instruc
tions
ENGLISH
9. ACCESSORIES
!
The installation must comply with Standards
EN 12453 and EN 12445.
When working in the box there are risks of cutting,
shearing, crushing hands due to the presence of
moving parts. Until the installation is completed,
the partially installed barrier must always be left
blocked and with the door and upper lid always
closed to prevent access to the electronic parts and
the moving mechanical pars.
Never install the beam before fixing the barrier body
and checking it. Until the installation is complete
never leave the barrier unguarded with the beam
fitted. Mark off the work site and prohibit access/
transit. If installation is outside, it must be done in
good weather without rain or gusts of wind. If it is
raining, an adequate shelter for the barrier must be
made until the mechanical and electronic installation
is complete.
Never manage the barrier by holding the board holder.
9.1 24V
"
FLASHING LIGHT
The flashing light indicates that the automation is
moving.
L
i
Install the flashing light in an easily visible position.
1. (
) Connect the flashing light to terminal
clamp J16 (3 W max).
2. If required, set the preflash (
PF
Advanced pro-
gramming)
3. Check that the device is working properly.
9.2 XBAT 24 EMERGENCY BATTERY
The XBAT 24 provides power to the automation system
in the event of a mains power supply failure. The
number of cycles that can be carried out with the
battery depends on various factors (state of battery
charge, time elapsing since the power outage, room
temperature etc.).
!
Recharge the battery before starting the system. The
full charging cycle of the XBAT 24 battery is 72 hours.
1. (
) Positioning the battery
2. Connect the battery to clamp J8 on the board
3. Set battery operation (
bF
Advanced program-
ming)
L
i
Disconnect the emergency battery if the automation
system is taken out of use.