B614 46
732998 - Rev.A
Tr
ansla
tion of the orig
inal instruc
tions
ENGLISH
repeat the procedure from the beginning or carry
out the remote memorisation procedure.
LC/RC - REMOTE CODE MEMORISATION
PROCEDURE
Additional radio controls can be memorised remotely,
i.e. without having to use the board directly, by using a
radio control that has already been memorised.
1. Near the E614 press buttons P1 and P2 if the radio
control already memorised (as OPEN or CLOSE at
the same time). The LED of the radio control
and LED DL4 or DL5 of the board begin to flash
for 5 secs.
2. Release both the buttons then press the button
already memorised within five seconds. From
this moment E614 stays in the learning phase for
around 20 secs.
3. Make sure that the LED DL4 or DL5 on the board
is still flashing and press the button of the radio
control that you wish to memorise. The LED (DL4
or DL5) on the board goes on as a steady light for
2 sec to then start flashing again for another 20
seconds during which it is possible to memorise
another radio control.
4. Wait for LED DL4 or DL5 on the board to turn off
before using the new radio control.
DS - MEMORISING RADIO CONTROLS
1. Set the required ON/OFF combination of the 12
dip-switches on the DS radio control. Avoid setting
all of them to ON or all of them to OFF.
2. Press and keep pressed the + key (OPEN program-
ming) or - (CLOSE programming). After pressing
the button for about 5 seconds, the corresponding
radio LED (DL4 or DL5) will start to flash to indicate
that the radio code learning phase has started.
3. Release the button, from this moment E614 stays
in the learning phase for around 20 secs.
4. Make sure that the LED DL4 or DL5 on the board is
still flashing and press the button of the DS radio
control that you wish to memorise for a few secon-
ds. The corresponding LED (DL4 or DL5) on the
board will turn on with a steady light for 1 second
and then turn off to indicate that the procedure
was completed successfully.
5. To add different codes, repeat the procedure star-
ting from point 1.
6. For additional radio controls, use the same ON/OFF
combination for the 12 DIP switches on the radio
control that has been memorised.
DELETING RADIO CONTROLS FROM MEMORY
!
This procedure cannot be reversed and cancels ALL the
codes of the radio controls memorised both as OPEN
and as CLOSE. The deletion procedure is only active
in the barrier status display mode.
1. Press and hold down the - button.
-
-
After holding LED DL5 down for approx 5 seconds
it begins to flash slowly, after another 5 seconds
flashing slowly and pressure maintained LEDs DL4
and DL5 begin to flash more quickly (beginning
cancellation).
-
At the end of the rapid flashing LEDs DL4 and
DL5 come on and remain steady to confirm the
successful cancellation of all the (OPEN and CLOSE)
radio codes in the board.
2. Release the - button. The LEDs turn
off, indicating that the codes were
deleted correctly.
-
