NetPA Ultra Series • DSP Configurator Software
AT Inputs
AT inputs receive signal from the Dante network when connected to an audio network. The
NetPA Ultra series amplifiers can receive 4 channels of audio via Dante.
Renaming an Input
NOTE:
Renaming an AT input in DSP Configurator affects the receiver name in
Dante Controller. Alternatively, renaming a receiver channel name in Dante Controller
affects the name displayed in DSP Configurator (see
Renaming a Receiver or
Transmitter
on page 78).
1.
Click the expansion or AT input name field.
Figure 62.
AT Input Name Field
2.
Delete or highlight the text and type the desired name.
Figure 63.
New AT Input Name
3.
Press the <
Enter
> key or navigate away from the field to confirm and apply the new
name. Press the <
Down Arrow
> key to navigate to and highlight the next name field.
Figure 64.
Renamed Expansion
NOTE:
Follow the same procedure to edit an AT Input name.
AT Inputs Overview
AT inputs allow an amplifier to receive signal from the audio network. Network audio routing
is done with Dante Controller (see
Dante Controller
on page 74).
Figure 65.
AT Inputs
AT Inputs Processing
The AT inputs contain three processor blocks and a meter block in their signal chain:
1.
Meter Block
2.
Filter Block
Renaming an Expansion or AT
Input
figure 26.
Expansion Input Name Field
figure 27.
New Expansion Input Name
figure 28.
Renamed Expansion
Expansion and AT
Inputs Overview
figure 29.
Expansion Inputs Panel
Expansion and AT Inputs
Processing
45
