NetPA Ultra Series • DSP Configurator Software
1
Pull
— (see
figure 35
on page 30) Pulls the configuration file and preset
configurations from the device and displays it in the DSP Configurator main
workspace.
2
Push
— (see
figure 35
on page 30) Pushes the configuration file and preset
configurations open in DSP Configurator to the connected NetPA U Series amplifier.
The check boxes indicate what is pushed when
OK
is selected. Pushing a selected
item overwrites that item on the device.
NOTE:
If only pushing selected presets, the preset selection dialog box opens
after clicking
OK
, allowing you to select which preset to push to the device.
If only pushing selected presets, mark them from the dialog box shown in figure 36.
Figure 36.
Preset Selection Dialog Box
4.
Once a push or pull is completed, the current state of the connected amplifier is
displayed in the DSP Configurator status panel and the device is ready for further
configuration.
Exit Live Mode and Enter Emulate Mode
1.
Click the
Emulate
button in the DSP Configurator menu bar (see figure 37,
1
).
Alternatively, select
Tools > Disconnect from Device
or press <
F6
> on the
keyboard.
Figure 37.
Emulate Button
2.
Click
OK
to confirm.
Figure 38.
Confirm Disconnect
Exit Live Mode and Enter Emulate
Mode
figure 2.
Confirm Disconnect
32
