NetPA Ultra Series • Operation
Figure 23.
Gain Controls
NOTE:
•
Set the attenuator of the attenuator blocks (via the created group) to -24
dB or lower to prevent an unexpectedly loud signal from getting to the
speaker when you first test the system (see figure 22).
•
For details on each processing block refer to
DSP Configurator
Software
on page 24.
e.
Verify that the gain structure through the signal chain is set appropriately, especially
that the mix points are set to the same gain and mute values.
f.
If using Dante inputs, make the ties in Dante Controller now (connection).
3
.
Unplug the IEC power cord from the amplifier.
4
.
Wire the outputs as shown in
figure 24 b
elow.
ATTENUATION
1
2
Input
To Speaker Load
5 mm
Captive Screw
Amplified
Output
1 2 3 4
NetPA U 1004
MIC/LINE INPUTS
1
2
STANDBY
LIMITER/PROTECT
SIGNAL
LINK
R
CLASS 2 WIRING
2
1
4
3
Tx Rx
RS-232
G G
3
4
1
2
3
4
100-240V 1.0 A, 50-60Hz
LINE OUTPUTS
CONFIG
REMOTE
8Ω/4Ω OUTPUTS
AT
NetPA U 1004
Tip
Sleeve
Ring
3.5 mm
Captive Screw
Balanced Mono
Tip
Sleeve
Jumper
Unbalanced Mono
Figure 24.
Bridging the Output
NOTE:
During bridged mono output, the + output from the odd channel becomes
the positive terminal and the + output from the even channel becomes the
negative terminal.
21
