MTPX Plus Series Setup Guide • Remote Control and Optimizing the Video
17
Command
ASCII command
(host to switcher)
Response
(switcher to host)
Additional description
RS-232 output inserts enables
Disable an RS-232
output insert port
EX$
*0Lrpt
}
Lrpt
X$
*0
]
Disable the RS-232 insert
on the
X$
output.
Enable an RS-232
output insert port
EX$
*1Lrpt
}
Lrpt
X$
*1
]
Enable the RS-232 insert
on the
X$
output.
Read RS-232 output
insert status
EX$
Lrpt
}
X%]
Show the status of the
RS-232 output insert.
Input signal level and peaking and auto calibrate
Set input signal
level
EX!
*
X^
Ipek
}
Ipek
X!
*
X^]
Set a specific pre-peak
level for the TP input.
Increment input
peaking
EX!
+Ipek
}
Ipek
X!
*
X^]
Increase the input pre-
peaking level by 1.
Decrement input
peaking
EX!
-Ipek
}
Ipek
X!
*
X^]
Decrease the pre-peaking
level by 1.
Read input peaking
setting
EX!
Ipek
}
X^]
Execute auto
calibration
EX!
*0AADJ
}
Aadj
X!
*2
]
{start}
Qik
]
{tie creation}
Aadj
X!
*
X&]
{finished}
Ipek
X!
*
X^]
{new value}
Tie input
X!
to output
1 and auto adjust the
peaking on input
X!
.
The
X&
value in the
response reports whether
the adjustment value was
within or outside of the
threshold.
NOTES:
•
Before issuing the auto calibration command:
1. Disconnect the power and RJ-45 cables at the MTP transmitter connected to
X!
.
Pre-Peak
is on.
2. Connect the two cables to the included MTP signal generator.
3. If the input cable is longer than 300 feet (90 m), place the
Pre-Peak
switch on the MTP signal
generator to on (up when the signal generator‘s RJ-45 connector is to the right as shown at right).
•
The MTP signal generator does not work on cable lengths over 400 feet (120 m). Set the level and
peaking to its maximum value of 255.
KEY:
X!
= Input number
00 – (maximum number of inputs for your model) (00 = untied)
X$
= RS-232 output insert port
MTPX Plus 168, 816, 1616
01 – 08
MTPX Plus 1632, 3216, 3232
01 – 16
X%
= RS-232 output insert status
0 = disabled
1 = enabled
X^
= Input signal level/peaking range 000 – 255
X&
= Threshold
0 = outside of threshold
1 = within threshold
Summary of Contents for MTPX 3232
Page 6: ......
