MTPX Plus Series Setup Guide • Front Panel Operation
12
Defining the Audio/RS-232 Wire Pair and Configuring the REMOTE Port
1.
To enter
configuration
mode, simultaneously press and hold the
CONTROL
buttons:
ENTER
,
PRESET
,
VIEW
, and
ESC
.
I / O
VIDEO
AUDIO
C O N T R O L
PRESET
ENTER
ESC
VIEW
C O N T R O L
PRESET
ENTER
ESC
VIEW
2
1
3 16
Protocol:
RS-422
RS-232
After
2 seconds
Press and hold the Control buttons.
Release the Control buttons.
Both I/O buttons light
with one flashing.
The flashing button
indicates the protocol.
Unlit input buttons indicate audio
.
Red input buttons indicate RS-232
.
Unlit
Red
(RS-232)
Unlit
(audio)
9600
Baud
rate:
115200
19200
38400
All Control buttons light with one flashing.
The flashing button indicates the baud rate.
NOTE:
The
CONTROL
and
I/O
buttons indicate the
REMOTE
port baud rate and
protocol as shown.
The
INPUT
buttons show the audio/RS-232 wire pair configurations.
2.
Release the
CONTROL
buttons.
NOTE:
These settings are protected when front panel
Lock mode 2
is selected.
You can view the configurations in
Lock mode 2
but you cannot change them
from the front panel; the actions are ignored and the
ENTER
,
VIDEO
, and
AUDIO
buttons flash (see
Selecting Lock Mode 2 or Toggling Between Mode 2 and
3.
To change an input audio/RS-232 wire pair configuration, press and release the
INPUT
button to toggle the configuration for that input.
2
1
3
Input button toggles:
Unlit --> red
OR
Red --> unlit
Press
NOTE:
You can also change the
REMOTE
port baud rate and protocol by pressing
the associated
CONTROL
and
I/O
buttons.
4.
Press and release an
OUTPUT
button to exit the
Serial Port Selection
and
configuration
mode.
Summary of Contents for MTPX 3232
Page 6: ......
