Extron electronics MTPX 3232, Setup Manual

Page: 14 / 39

MTPX Plus Series Setup Guide • Installation 6
Inputs
ATTENTION:
Turn the input and output devices off and unplug their power cords.
ATTENTION :
Éteindre tous les appareils d’entrée et de sortie puis retirer les câbles
d’alimentation.
1
TP inputs
— (see
Rear Panel
on page 5) Connect up to 8, 16, or 32
(depending on the matrix size) compatible TP inputs to the Inputs RJ-45
connectors.
NOTE:
Configure the switcher for the appropriate input (RS-232 or
audio) for each TP input (see on page 11).
2
Local RGB (VGA) inputs — Connect analog computer video sources to
the Local Inputs 15-pin HD female connectors.
NOTE: These connectors can also accept HD component video,
component video, S-video, or composite video.
3
Local audio inputs — Connect balanced or unbalanced stereo audio inputs to the
Audio 5-pole captive screw connectors.
LR
Unbalanced Input
Balanced Input
(high impedance) (high impedance)
Ring
Sleeve (s)
Tip
Sleeve
Tip
Sleeve
Tip
Tip
Ring
Do not tin
the wires!
Figure 5. Audio Input Connector Wiring
4
Input Select switches
(switchers other than the MTPX Plus 128) — Set the
INPUT SELECT
ON
LOCAL
RJ - 45
1 2 3
Input Select DIP switches for each input that can be either local or on TP
cable from an MTP transmitter.
RJ-45 (down) for an input from an MTP transmitter (
1
)
Local (up) for a local (RGB video and audio) input (
2
and
3
)
NOTE:
• MTPX Plus 1616 and smaller have Input Select DIP switches for inputs 1
through 3.
• MTPX Plus 1632 and larger have Input Select DIP switches for inputs 1
through 6.
RS-232 Output Inserts
5
RS-232 Output Insert connectors — For bidirectional RS-232 data that is routed to a
specific (unswitchable) TP output, connect a serial device to one of the RS-232 Output
Insert 3-pole captive screw connectors.
Receive (Rx)
Transmit (Tx)
Ground ( )
Bidirectional
RS-232
Device
Ground ( )
Receive (Rx)
Transmit (Tx)
Rx Tx
Do not tin
the wires!
Figure 6. RS-232 Output Inserts Connector Wiring
NOTE:
• Each RS-232 OUTPUT INSERT must be enabled (see the RS-232 output
inserts enables SIS commands on page 17).
• The switch time for the RS-232 output insert is 50 ms.
5
6