MGP Pro Series • Operation
29
Comm./IP Configuration Menu
Use the
COMM./IP CONFIGURATION
menu to view and edit the serial communication port
configuration and the MGP Pro IP addresses. The
COMM./IP CONFIGURATION
menu
consists of two levels:
View
and
Edit
.
Figure 19.
Communication/IP Configuration Menu Flow
Viewing serial port and IP settings
When you first reach the
COMM./IP CONFIGURATION
menu, the view level is displayed. At
this level, all the screens that you cycle through by pressing
NEXT
show the current settings.
The
ADJUST
knobs are disabled and you cannot make changes from the screens.
To view the serial port and IP settings:
1.
Press
MENU
repeatedly until
COMM./IP
CONFIGURATION
is displayed.
2.
Press
NEXT
repeatedly to cycle through the screens displaying the current settings for
the serial port, MAC address, DHCP mode, IP address, gateway address, and subnet
mask.
3.
Press
MENU
to return to the
COMM./IP
CONFIGURATION
screen.
Making changes to the serial port and IP configuration
To make changes to the serial port configuration, IP address, DHCP mode, gateway
address, and subnet mask, access the edit level screens as follows:
1.
With any
COMM./IP
CONFIGURATION
menu view-level screen displayed, press the
Enter
button and hold it until the
Serial
Config
screen appears (approximately
2 seconds).
2.
Press
NEXT
repeatedly to cycle through the edit level screens.
3.
To enter or change information on each screen, rotate the horizontal
ADJUST
knob (
[
)
to move the angle brackets to the desired setting. Rotate the vertical
ADJUST
knob (
{
)
to adjust the setting.
19
