7
DXP HD 4K Series • Setup
NOTE:
on the previous page show
the DXP 88 HD 4K, with 8 inputs and 8 outputs, and
DXP 1616 HD 4K, with 16 inputs and 16 outputs.
•
The rear panels of the DXP 44, 84, and 88 are identical
except for the number of inputs and outputs.
•
The rear panels of the DXP 168 and 1616 are identical
except for the number of outputs (both have 16 inputs).
Input connectors
— Connect HDMI source devices to
these female 19-pin type A HDMI input connectors for
video input.
LockIt™ cable lacing brackets, one for each HDMI input and
output connector, are provided with the DXP HD 4K. These
brackets can be used to secure the HDMI cables to the
DXP connectors to reduce stress on the HDMI connectors
and prevent signal loss due to loose cable connections (see
Securing HDMI Cables with the LockIt HDMI Cable Lacing
Bracket
Output connectors
— Connect HDMI output devices
to these female 19-pin type A HDMI output connectors
for buffered video output (see
with the LockIt HDMI Cable Lacing Bracket
Reset LED
— While you are holding the
Reset
button, this green LED blinks every 3 seconds to
indicate the level of reset that will occur if the button
is released at that point (see
D
Reset
button
).
Reset button
— This recessed button initiates four
levels (modes) of reset. Use a pointed object such as a
small screwdriver to press and hold the
Reset
button.
•
Factory firmware reset (mode 1)
— Hold the
Reset
button while powering up the switcher to restore the DXP to
the factory firmware for a single power cycle.
NOTE:
This type of reset maintains all the current user
settings, such as audio adjustments, IP settings, and
the configuration.
•
Event reset (mode 3)
— This mode is not supported. If
you select it by accident, the Reset LED blinks three times
and no reset occurs.
•
IP settings reset (mode 4)
— While the DXP is running,
press and hold the
Reset
button until the LED blinks twice
(approximately 6 seconds). Release the button and press it
again momentarily to reset the switcher IP functions.
NOTE:
An IP settings reset does not replace any user
installed firmware.
1
1
RESET
DXP 88 Series
RESET
DXP 1616
Series