11
DXP HD 4K Series • Setup
Tip (+)
Sleeve ( )
RCA Connector
Figure 8.
RCA Plug for S/PDIF Audio Outputs
The DXP 168 and 1616 have four S/PDIF connectors while the
DXP 44, 84, and 88 have two.
AC power connector
— Plug a standard IEC power cord into
this connector to connect the switcher to a 100 VAC to 240
VAC, 50 or 60 Hz power source.
Securing HDMI Cables with the LockIt HDMI Cable Lacing
Bracket
Use a LockIt HDMI Cable Lacing Bracket to securely fasten each
HDMI cable to the switcher as follows.
1.
Plug the HDMI cable into
the panel connection (see the
illustration at right,
1
).
2.
Loosen the HDMI connection
mounting screw from the
panel enough to allow the
LockIt lacing bracket to be
placed over it (
2
). The screw
does not have to be removed.
3.
Place the LockIt lacing
bracket (
3
) on the screw and
against the HDMI connector,
then tighten the screw to
secure the bracket.
ATTENTION:
•
Do not overtighten the HDMI connector mounting screw.
The shield it fastens to is very thin and can easily be
stripped.
•
Ne serrez pas trop la vis de montage du connecteur
HDMI. Le blindage auquel elle est attachée est très fin et
peut facilement être dénudé.
4.
Loosely place the included tie wrap around the HDMI connector
and the LockIt lacing bracket as shown (
4
).
5.
While holding the connector securely against the lacing
bracket, use pliers or similar tool to tighten the tie wrap, then
remove any excess length.
3
3
3
1
1
4
4
2
2
