Cable Cubby
®
Products • Installation
Installaton, cont’d
2-10
Installng the shelf assembly (CC 300, 600, and 800)
From the underside of the Cable Cubby, gently push the AAP
shelf assembly into the desired position at the desired elevation.
Ensure there is enough space above the AAP assembly for the
Cable Cubby lid to close completely. Secure the AAP shelf
assembly into position with four Phillips head screws.
N
If the AAP shelf assembly does not slide easily into the
cubby, loosen the AAP mounting nuts. Retighten the
AAP mounting nuts once the AAP shelf assembly is
installed in position.
Adjustng the cable poston (CC 200)
The Cable Cubby 200 has three cable stand-offs (figure 2-6) that
allow you to set the height of the cables inside the enclosure.
Adjust the cable height as follows:
Loosen screws to
adjust side to side.
Remove screws to
adjust height.
Cable Stand-Off
Figure 2-6 — Cable Cubby 200 height adjustment
1
.
Insert the stand-off into the Cable Cubby and align the
stand-off with one set of horizontal slots in the side of the
enclosure. Choose the adjustment height that best lifts the
cable connectors off of the cable pass-through AAP and
still allows the lid to be closed.
2
.
Loosely install the Phillips head screws and washers as
shown in figure 2-6.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
