Cable Cubby
®
Products • Installation
2-3
Preparng the Routng Template
Extron provides metal templates for the Cable Cubbies at no
charge. See Routing Template Part Numbers, in appendix A,
Reference Information
, for part numbers. Extron recommends
using this template as a guide to cut the hole in the table where
the cubby will be installed.
N
The metal routing template is reusable. Do not discard
this template when the installation is complete. Save it
for installing Cable Cubby models of the same size.
1
.
Cut 1/2" x 4" strips of soft, finished lumber at least
long enough to span the distance between the desired
installation location on the mounting surface and the edges
of the mounting surface (figure 2-1).
These strips raise the routing template above the mounting
surface to provide room for the router’s collar, protect the
mounting surface, and extend the routing template’s reach
so that it can be clamped to the edge of the surface.
Mounting
Surface
Edge
Mounting
Surface
Edge
Wood Thickness
0.5" / 1.3 cm
Width of Mounting Surf
ace
Routing Template
Wood Strip
Height
4" / 10.2 cm
Minimum
4 Screws
Wood
Strips
Figure 2-1 — Prepared CC 300 mounting template
2
.
Using four or more short wood screws, secure the
mounting template to the lumber strips.
C
Do not allow the wood screws to protrude through
the bottom of the wooden strips. Protruding screws
will mar the table when the template is used.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
