Cable Cubby
®
Products • Installation
Installaton, cont’d
2-6
Preparng the table wth a hole saw
(Cable Cubby 300C only)
Prepare the table with a hole saw as follows:
1
.
On the tabletop or other installation surface, mark the 6"
circle, then find and mark the center of the circle.
W
Wear safety glasses when operating the drill.
Failure to comply can result in eye injury.
2
.
Using a portable drill with a 6" (or 152 mm) hole saw,
carefully cut the opening in the table surface at the
desired location (figure 2-3). Extron is not responsible for
improperly positioned Cable Cubbies.
C
Use a portable drill with sufficient power to handle
the 6” hole saw. Exercise caution when handling
the drill and hole saw. Take care to protect the
mounting surface from damage.
Figure 2-3 — Cutting the opening with a hole saw
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
