Extron electronics 6400s, User Manual

Page: 52 / 148

Operation, cont’d
Fiber Matrix 6400 Switcher • Operation
3-26
Performing a system reset from the front panel
The front panel reset is identical to the
E
ZXXX
}
SIS command (see chapter 4,
“Programmer’s Guide”). A system reset clears all ties and presets, all output mutes,
and resets all I/O grouping.
Reset the switcher to the factory default settings by pressing and
holding the
View button and Esc button while you apply AC power to the switcher.
N You must apply power from an unpowered state. Applying the redundant power
with primary power already applied does not reset the switcher.
N
System reset does not reset the Internet protocol (IP) settings or replace user-
installed firmware.
100
-24
0V
50
/60
Hz
1.2
A M
AX
.
100
-24
0V
50
/60
Hz
1.2
A M
AX
.
REDUND
ANT
PRIM
AR
Y
LIN
A TX
LINK
1
RX
LINK
2
B
TX
LIN
K
A
TX
LIN
K
1
RX
LINK
2
B TX
LIN
K
1
RX
LINK
2
C
TX
LINK
1
AN
AH
EIM
, C
A
PRI
MAR
Y PO
WER
SUP
PLY
41 - 4
8
49
-
5
6
57
-
6
4
CONTROL
T VIEW
ESC
Press and hold the View and Esc
buttons while you apply power to
the switcher.
Release the View and Esc buttons.
Power
The switcher flashes the button
indicators green, red, and
amber and then turns them off.
Continue to hold the View and Esc
buttons until all input and output buttons
return to either unlit or to background
illumination.
Background illumination
The buttons on the front panel can be set to provide amber background
illumination at all times or the background illumination can be turned off. To
toggle the background illumination on or off, press and hold the Input 1 and
Input 2 buttons simultaneously for approximately 2 seconds.
1 2 3
17 18 19 32
16
Press and
hold the Input 1 and Input 2
buttons simultaneously to toggle
background illumination mode on or off.
After approximately 2 seconds, release
the Input 1 and Input 2 buttons.