Extraflame LUCREZIA IDRO LCD, Manual

Page: 33 / 48

USER PARAMETERS
33
Chapter 8
Adjustment table
LACK OF
FUEL
Increase the percentage value by 5 points and try the stove with the new
calibration for at least half an hour. If the problem is attenuated, but not solved,
increase by another 5 points. Repeat the operation until the problem is solved.
If the problem cannot be resolved, contact the after-sales service.
EXCESS OF
FUEL
Decrease the percentage value by 5 points and try the stove with the new
calibration for at least half an hour. If the problem is attenuated, but not solved,
decrease by another 5 points. Repeat the operation until the problem is solved.
If the problem cannot be resolved, contact the after-sales service.
When the adjustment has been made, press button 1 to conform and escape.
SPRINGS AUTOMATIC CLEANING TIMES
Display D1 Display D2 Function
08:00 UT G Automatic cleaning start time
22:00 UT H Automatic cleaning end time
These 2 parameters allow to establish the time period within which automatic cleaning of the springs is
active.
To access these parameters, press button 3 and hold it down pressing button 5.
Once entered user parameters, move with button 5 until “
UTG ” appears on display D2”.
Parameter G (D2=UT G; D1=Ex. “08:00”)
Allows to adjust, using buttons 2 and 3, the start of the time span where the automatic cleaning is active.
To confi rm and continue programming, press button 5.
Parameter H (D2=UT H; D1=Ex. “22:00”)
Allows to adjust, using buttons 2 and 3, the end of the time span where the automatic cleaning is active.
To confi rm and continue programming, press button 5.
At this point, in the times not included in the created time span, the automatic cleaning will result
disabled.