PRODUCT FUNCTIONALITY
25
Chapter 5
The stove you have purchased uses pellet fuel. This type of material is obtained from natural waste from
the machining of wood. By means of a special process that does not require the use of any binding agent
and additive, the waste is compressed in industrial machinery under high pressure and they become solid
wooden pellets. IT IS PROHIBITED to burn non-pelletised raw materials inside our stoves. The failure to
comply with these prescriptions voids all guarantees and could jeopardise the safety of the appliance.
The following recommendations must be followed the fi rst two or three times the stove is ignited:
It is possible that slight odours are produced due to the drying of the paints and silicones used. Do not
remain in the environment for long periods.
Do not touch the surfaces as they could still be unstable.
Air the room well several times.
The hardening of the surfaces is terminated after several heating processes.
This appliance
must not
be used to burn waste.
IGNITION
Before switching the stove on the following points must be verifi ed:
1.
the feed-box must be full of pellets
the combustion chamber must be clean
The brazier must be completely free and clean
check the hermetic closure of the fi re door and the ash drawer
make sure the power supply cable is connected correctly
the bipolar switch in the rear right part must be positioned on 1
Press button 1 for 3 seconds: display D1 will show “
2.
START
”, while display D2, starting from number 8,
the numbers will decrease every second. In the phase the appliance performs self-analysis to check the
functionality of each individual electric component. When this cycle has been completed, display D1
will show “
IGNITION
”, while display will show “15” (these are the minutes when the stove attempts the
ignition phase and decreases by 1 every minute that passes).
The fi rst time the product is used, even if the feed-box is full, there is the possibility that the pellets are
not distributed into the combustion chamber for the fi rst 15 minutes. This is because the pellet feed
worm screw is empty. If no fl ame has developed in the stove after 15 minutes D1 will show “
IGNITION
FAILURE
”.
If points 1 and 2 have been performed correctly, when the fl ame is developed the stove will pass to
3.
START
” mode.
On termination of the start phase the stove will pass to normal functioning: display D1 will show the
4.
room temperature while display D2 will show the work power.
ATTENTION!!!
Do not use any infl ammable liquids for ignition
1.
Do not allow the bag of pellets to come into contact with the boiling hot stove during
2.
the fi lling phase
In the case of continuous no ignition, contact an authorised technician
3.
Summary of Contents for LUCREZIA IDRO LCD
