104
MB1 User Manual
© 2016 Expert Electronics
MAIN SCREEN DESCRIPTION
To transfer the IQ signal in the CW Skimmer you need to adjust the settings of the audio
device in the RX I Q out put category, it consists of:
·
Enable checkbox - Enable the IQ signal transfer from the EpertSDR2 to the CW Skimmer.
·
Driver – audio device driver type.
·
Out put – audio device physical output.
·
Channels – amount of the used channels of the audio device.
·
Sample rat e – sampling frequency.
·
Buf f er size – buffer size.
·
Lat ency – signal delay time.
Note:
(
If CW Skimmer is installed on the transceiver's PC, then for the signal output you need to use
Virtual Audio Cable.
·
Sync f requency - ExpertSDR2 set the CW Skimmer frequency.
·
Tune f requency f rom CW Skimmer - CW Skimmer set the ExpertSDR2 frequency.