EXFO T100S-HP Essential, User Manual, Page: 59 / 70

T100S-HP User Guide 59
11. Error and Warning Messages
Message Possible Cause Troubleshooting
WARNING:
User calib. Err press "enter" The user power calibration is
not correct (see section
Performing Power Calibration,
p. 37
).
As the user calibration is not valid,
the T100S-HP implements the
default power calibration value
instead.
ERROR:
No factory calib.
Turn Power off No factory calibration. Turn off the system and check the
integrity of electrical connections.
If this error message shows
continuously, please contact the
EXFO customer support service (see
section
Contact Information, p. 4 ).
VALUE error
Press Enter. The system parameter you are
trying to configure is outside
the valid range (see section
Valid Ranges for Parameter
Settings, p. 14
).
Press Enter .
All changes are discarded and the
previous parameter value is
restored.
Limit Switch
Turn Power off Mechanical problem. Turn off the system and immediately
contact the EXFO customer support
service (see section
Contact
Information, p. 4 ).
EEPROM error
Turn Power off Electrical problem. Turn off the system and contact the
EXFO customer support service (see
section
Contact Information, p. 4 ).
Referencing Error 1 or 2
Press Enter The system's internal
wavelength referencing
operation has failed. Press Enter to restore the current
system settings.
Internal wavelength referencing
remains unchanged.
Referencing Warning 1 or 2
Press Enter