EXFO T100S-HP Essential, User Manual, Page: 21 / 70

T100S-HP User Guide 21
2. Installing and Connecting the Product
2.1 Unpacking and Installing the Product
Subject When used as a stand-alone bench-top product, this product is designed so that the feet
leave enough room under the product to enable proper ventilation.
The apertures (under the product) and the fan (behind the product) are used for the
inside ventilation.
Procedure 1. Pull out the product from its packaging: hold it by its two retractable handles and
keep it horizontal.
2. Set the product on a flat stable surface free of excessive vibration.
3. Keep the original shipping container, for use in case the product needs to be returned
to EXFO for repair or servicing.
4. Allow the flow of air from the cooling fan to circulate freely around the product and
remove any equipment or paper that could block the air-flow.
5. On the rear panel (see Figure 2, p. 18 ), make sure the power switch is set to 0 .
6. On the front panel, in the OUTPUT area, make sure the key-lock switch is in STBY
position before applying power.
7. Place the T100S-HP in the wanted operating position as illustrated in Figure 3, p. 21 .
To tilt the T100S-HP upward, deploy the two retractable legs located below it.
Figure 3: Possible operating positions (bench-top)
Caution
• Make sure there is sufficient clearance below and at the back of the
product to ensure proper ventilation. The apertures (under the product)
and the fan (behind the product) are used for the inside ventilation.
• If you plan to rack-mount this product, make sure to allow at least a 15-
mm (0.6 inches) gap between two products.
• The T100S-HP is not designed for outdoor use. To avoid the possibility of
injury, do not expose the product to rain or excessive moisture. Do not
operate the product in the presence of flammable gases or fumes.
Important
When unpacking, handle the product with care and do not damage the
original shipping container in case the product needs to be returned to
EXFO.