Exabyte MAGNUM 1X7 LTO AUTOLOADER, Product Manual

Page: 152 / 162

136
P
RODUCT
M
ANUAL
1012581
A
PPENDIX
C—E
RROR
M
ESSAGES
In Enet Mode The autoloader is executing a
command issued from the Remote
Management utility (see Chapter 4 )
when a command is issued from the
operator panel.
Wait until the autoloader has finished its
current operation, then retry the operation.
In Security Mode
Choice Rejected
Autoloader security has been set
from the application.
Disable autoloader security from the
application.
Library is BUSY The autoloader is executing a
command issued from the
application when a command is
issued from the operator panel.
Wait until the autoloader has finished its
current operation, then retry the requested
operation.
Media Removal
is Locked by Host
Media removal from the autoloader
has been prevented through the
application.
Turn off media removal prevention from
the application and retry the operation.
Over Temperature The tape drive’s temperature limit
has been exceeded, and the
cartridge has been ejected from the
drive.
ƒ
Wait until the autoloader has cooled,
then unload the cartridge to a cell and
re-load it into the tape drive.
ƒ
Check the room temperature. The
ambient temperature must be no more
than 40°C (104°F).
ƒ
Provide additional air flow around the
autoloader to improve cooling.
POST Failed The autoloader encountered an
error during its power-on self-test.
1. Reset the autoloader and retry the
operation.See page 74 for reset
instructions.
2. If the error persists, contact Exabyte
Technical Support (see page iii ) or your
service provider.
Sequential Mode An application tried to issue
commands to the autoloader while
it was in Sequential mode.
Set the autoloader to Random mode (see
page 38 ).
Servo Error The autoloader carousel has
experienced a problem.
1. Reset the autoloader and retry the
operation.See page 74 for reset
instructions.
2. If the error persists, contact Exabyte
Technical Support (see page iii ) or your
service provider.
Servo Jammed The autoloader carousel has
experienced a problem.
1. Reset the autoloader and retry the
operation.See page 74 for reset
instructions.
2. If the error persists, contact Exabyte
Technical Support (see page iii ) or your
service provider.
Table C-1 Autoloader error messages (continued)
Error Message Description Corrective Action