Exabyte MAGNUM 1X7 LTO AUTOLOADER, Product Manual

Page: 65 / 162

O
CTOBER
2006 M
AGNUM
1
X
7 LTO A
UTOLOADER 49
V
IEWING
I
NFORMATION ON THE
H
OME
(S
TATUS
) P
AGE
V
IEWING
I
NFORMATION ON THE
H
OME
(S
TATUS
) P
AGE
The Status page is the “home page” for the utility. The Status page provides
information in four sections:
Library Information
Library Status
Tape Drive Status
Inventory
At the bottom of the Status page is an Update button that refreshes the
information on the page. An option for automatically refreshing the page is
also available. Check this option to have the information refreshed
approximately every 6 seconds.
The information available on the Status page is described below.
L
IBRARY
I
NFORMATION
The Library Information section includes the following information for the
autoloader and tape drive:
Field Indicates the...
Device library and tape drive
Vendor vendor identification value (EXABYTE) as reported in
response to an INQUIRY command from an application
Product product identification value as reported in response to an
INQUIRY command from an application:
ƒ
“ LTO 1x7 2U “for the autoloader
ƒ
“Ultrium-TD2” or “Ultrium-TD3” for the tape drive
Note: If you change the autoloader’s emulation mode
from its default (Native), the autoloader’s Product
Identification value changes to match the new
emulation mode (see page 31 ).
Serial Number autoloader or tape drive’s serial number
Firmware Rev autoloader or tape drive’s current firmware revision level
SCSI ID autoloader or tape drive’s current SCSI ID. You can change
the SCSI IDs from the utility’s Configuration page (see
page 53 ).