(Continues on next page)
D
E
F
4. Loop a cable tie into the bottom of the vertical slot in
the EBB support, and out of the lowest horizontal slot
(
D
).
5. Slip the end of that cable tie through the loop at the end
of the support wire (
E
).
6. Close and cinch the cable tie (
F
), pull it tight, and cut off
the excess length.
§5.7 Complete the wiring, continued
65
Summary of Contents for AxiDraw MiniKit 2
