4.9 Add the Y Carriage
1. Set the Y Carriage in place atop the X Carriage, with
its idler pulley pointing down and towards the front
of the X carriage – towards the side with the belt
loop, not the loose belt ends.
2. Set one of the M4×12 Low Profile Screws
#27
through a Roller Wheel
#38
and set it on top of one
of the SemiHex Standoffs
#34
on the right side of
the X Carriage.
3. Hold the base of the SemiHex Standoff steady with
the 10 mm Low-profile Wrench
#5
while you tighten
the wheel securely in place with the short side of
the Hex L-wrench. Take care to not rotate the stand-
off.
4. Repeat these steps to add the other roller wheel to
the other SemiHex Standoff.
45
Summary of Contents for AxiDraw MiniKit 2
