5. Tighten both wheels securely in place using the 2.5 mm Hex L-wrench
#4
and, the 7 mm Low-profile
Wrench
#7
to steady the locknut (
C
). Important: Do not overtighten the wheels. The wheels should be
secure in place but the outer clear plastic part of the wheel must be able to turn freely.
§3.7 Front X Wheels, continued
Tip:
In order to grip these nuts and tighten them, you will need to keep the nut and washer pressed
up against the carriage plate. Hold the Locknut against the plate with your thumb while you turn
– not press – the screw with the 2.5 mm Hex L-wrench.
C
30
Summary of Contents for AxiDraw MiniKit 2
