EMV400S FHD / EMV400SSD Mobile DVR
81
Auto Lock:
Check the box and the events will be recorded in a write protected segment of the
storage (will not be overwritten). The mobile DVR will lock a period of time when the alarm
occurs. The length of the time depends on mobile DVR setting (see
6.5.3 Lock / Format
).
FTP Upload:
Check the box to enable uploading recordings to the FTP server function. To setup
the FTP server, please refer to
6.7.6 FTP
.
Send to Xfleet:
Check the box to send the event data to the Xfleet system. Note that for the
Xfleet system to receive event data from the mobile DVR in order to perform the event actions
on Xfleet system, this function must be enabled.
FTP Upload File Type:
Select MP4 file type to upload videos to FTP server; select JPEG file type
to upload snapshots to the FTP server.
Alarm Output:
Select an alarm output relay. When an alarm is triggered, the signal will be
transmitted through the selected alarm output relay.
Output Type:
Select an output type when an alarm is triggered.
Timeout: Select this option and then set up the Timeout Duration in the field below, the
alarm output will last for the setup duration time (10 ~ 150 seconds).
Permanent: Alarm will remain active until the user presses the “Enter” key on the IR
Remote Control or resets the alarm remotely.
Transparent: Alarm output remains as long as the alarm input is active.
Trans + Timeout: Alarm output continues until event ends, then continues for the setup
duration time (10 ~ 150 seconds).
Timeout Duration:
This function only appears when you select
Timeout
or
Trans + Timeout
options in the Output Type drop-down list. Select a duration time for the motion event. The
alarm output will last for the setup duration time between 10 and 150 seconds.
Main Monitor/Call Monitor:
Select
Full Screen
to force the camera which detects motion to
display full screen on the monitor. The full screen camera view will last according to the Output
Type selected in the field above.
Edit Motion Grid:
Press the button to bring up the Motion Setting menu. To edit the motion
grids, please refer to the instructions later in this section.
Apply To:
Click the button to apply the same settings to the desired cameras.
Save:
Click to save the settings.
