EVER POWERLINE GREEN 33 LITE UPS Range Operating Manual
Type 01 2016-10-27 12:12
Technical Service, tel.: +48 61 6500 400
www.ever.eu
86
116
DelayTimer
Binary parameter, quoted in seconds and used to switch off the inverter
operation with a given delay. This is to be configured to set the required
delay value prior to setting the bit “Command to switch the UPS to the
waiting mode” by the software.
117
CapacityStandby
Binary value quoted as a percentage of the available capacity, used to
delay the unit’s exiting the SUSPENDED (VIGILANCE) mode before
reaching the required battery charge level.
118
CapacityBattery
Binary parameter, indicates the capacity of an individual battery.
119
NbrOfStringsBatteries
Binary parameter, specifies the number of battery sections currently
connected to the UPS unit (comprises the sum of internal and external
batter sections).
120
Reserved
121
ChargingCurrent
Binary parameter, specifies the charging current, quoted with the
resolution accuracy of 0.1 A
122-123
Reserved
124
IncorrectMainsParametersCounter
Binary parameter, specifies the number of events where the mains
voltage drops or increases or frequency changes to exceed the criteria for
the correct mains parameters.
125
OverloadsCounter
Binary parameter, specifies the number of UPS unit switching off events
due to exceeding the maximum allowed continuous active power level
over a pre-set period of time.
126
ShortCircuitsCounter
Binary parameter, specifies the number of UPS unit switching off events
due to UPS output shorting while generating output voltage from the
inverter.
127
DischargesCounter
Binary parameter, specifies the number of UPS unit switching off events
due to batteries becoming discharged where “discharging” is defined as
dropping to 0 of the parameter/word “uiPojemnoscAku” in the
“strInformacje” structure.
128
RecOverTempCounter
Binary parameter, specifies the number of events where maximum
permitted temperature was exceeded for selected monitored rectifier
components, leading to a fault/failure state with subsequent event
reaction that is appropriate for this particular range of UPS units.
129
InvOverTempCounter
Binary parameter, specifies the number of events where maximum
permitted temperature was exceeded for selected monitored inverter
components, leading to a fault/failure state with subsequent event
reaction that is appropriate for this particular range of UPS units.
130
TimeOverload
Value which specifies the duration of the period the unit operated under
overload conditions, the time quoted in minutes.
131
TimeNormalMode
Value which specifies the duration of the period the unit operated in the
normal mode (with no warnings or faults/failures), the time quoted
in minutes.
132
TimeBatteryMode
Value which specifies the duration of the period the unit operated in the
BATTERY mode, the time quoted in minutes.
133
TimeBypassMode
Value which specifies the duration of the period the unit operated in the
bypass mode, the time quoted in hours.
134-136
Reserved
137
Event1*
KKMM
138
NNDD
139
GGSS
140
Event2*
KKMM
141
NNDD
142
GGSS
143
Event3*
KKMM
144
NNDD
145
GGSS
146
Event4*
KKMM
147
NNDD
148
GGSS
149
Event5*
KKMM
150
NNDD
151
GGSS
152
Event6*
KKMM
153
NNDD
154
GGSS
155
Event7*
KKMM
156
NNDD
157
GGSS
158
Event8*
KKMM
159
NNDD
160
GGSS
Summary of Contents for W/PGRLTO-3310K0/00
Page 1: ......
