Eurotrac T13-F, Operation Manual

Page: 9 / 81

Page 9/81
April 2021 W11 - W12S -W12F - W13F - T13F | Operation manual
14. Do not transport people on this loader.
15. Do not drive the loader on soft surfaces if you do not know the road conditions exactly.
16. Before operating this loader, the roll cage must be raised, and the pin should be in the locking position.
17. Apart from pulling with the outer hook, no other pulling is permitted for loaders.
18. Do not remove the radiator cap when the engine is hot, otherwise, it can cause severe burns. Allow to remove
the radiator cap after cooling.
19. Do not attempt to touch the exhaust pipe and muffler when the engine is running or has just been switched
off, as this may result in severe burns.
20. After opening the engine back cover, do not try to start the engine. If you must start, beware of the fan.
21. Never refuel the unit while the engine is running.
22. When injecting the fuel, it can stop when the refueling gun automatic is cut off. Don’t inject too much. When
refueling, do not smoke, do not store or use the fuel at a fire place.
23. Do not check the engine oil while the engine is running.
24. Do not use the battery in this unit to start other vehicles.
25. The maximum ear noise measured value of this loader is 88dB. For your good health, wear personal protective
equipment (such as earplugs) when controlling the machine, to reduce damage from machine noise.
26. Always exercise good common sense, stay alert and be aware of what is happening around the loader all times.
27. When a vehicle rolls or rolls-over, the loader roll cage can protect driver’s safety completely, do not jump. At
this point your hands should get hold of the steering wheel; feet clamp the mounting bracket under the
orientation column. The damaged roll cage can’t be reused after repair, unless you get the written
authorization or approval from Eurotrac Construction Equipment.
28. The rated capacity stated in this manual is based on the machine standing on solid level ground. When
operating on non-standard ground (such as soft, uneven ground or on slopes), you should consider the impact
on the load capacity.
3.3 Mechanical responsibilities
This chapter must be read and thoroughly understood prior to performing any maintenance on this equipment.
WARNING
Failure to comply with the following safety precautions can result in serious injury or death as well as equipment
damage.
1. Always follow the Station Safety Rules. If a written list of safety rules is not posted at the station, obtain one
prior to operating this loader.
2. Always review the Operator Responsibilities Section prior to operating this equipment.
3. Always keep hands and feet away from rotating parts and tires. Wear secure clothing.
4. Always wear suitable footwear when operating or servicing this equipment. Avoid wearing loose-fitting
clothing that might get caught in moving parts.
5. Always stop the engine when adjusting fan and alternator belts.
6. Always keep hands clear of the cooling fan.
7. Do not remove the radiator cap when the engine is hot, as serious burns may result. Allow the radiator to cool
before removing the cap.
8. Do not run the engine long time in a closed room.
9. Do not start the engine in an environment where there is a high risk of explosion.
10. Do not check the engine oil while the engine is running.