Eurotrac T13-F, Operation Manual

Page: 38 / 81

Page 38/81
April 2021 W11 - W12S -W12F - W13F - T13F | Operation manual
At this time, press the manual regeneration switch again, and the engine enters the regeneration state.
The whole process lasts about 25-30 minutes. The following points will cause manual regeneration to stop:
1.
The parking is in the unlocked position or the regeneration lock switch is disabled.
2. The engine throttle position has changed.
3. The key switch is off.
CAUTION
In the case of DPF regeneration interruption, the next DPF manual time interval will be shortened. When manual
regeneration is not carried out normally, the particles in DPF will exceed the limit, and the engine speed and torque
will be limited. Recovery from backup mode requires professional service personnel.
WARNING
During the regeneration process, DPF, the temperature around the exhaust pipe and the exhaust gas temperature
are high, and it is suitable to be carried out in the surrounding places without people or inflammables. Additional,
the harmful carbon monoxide that contains colorless, tasteless in exhaust, can cause poison after inspiratory.
Therefore, DPF regeneration should be carried out outdoors with good ventilation and open space.
CAUTION
If the regeneration process is not halfway through, but you want to continue working, you can press the
regeneration lock switch and then continue working. After the work is completed, you need to drive the car to an
empty position as soon as possible and repeat the above regeneration operation. Until the regeneration process is
completed.
General preventive measures
• Do not operate any levers or pedals if anyone is in any position to be hurt by the machine's movement.
• Pay extra attention when working in narrow congested areas or in case of blind-travel.
• Always look around in all directions before changing your direction of travel.
• Always follow all safety rules on each particular site during operation.
• Maintain a running speed which is compatible with the load and the ground conditions.
• Slow down when approaching corners.
• Observe pedestrians carefully and do not follow the vehicle in front too closely.
• Do not brake sharply and only select neutral once the loader has effectively stopped.
• Maintain a safe distance from the edge of loading wharf.
• When turning, pay close attention to the trajectory of the buckets.
1. Regeneration confirmation light is on
2. High exhaust temperature light stays on