Eurotrac T13-F, Operation Manual

Page: 59 / 81

Page 59/81
April 2021 W11 - W12S -W12F - W13F - T13F | Operation manual
ELECTRICAL FAULT CODES
Code
636 7 Engine Position Sensor
Large phase shift between NE pulse
and G pulse
• Battery voltage is normal
• Sensor supply voltage VCC# is normal
• NE signal is normal
• G signal is normal
• Engine speed is 350 rpm or more
• Coolant temperature is 10 °C (50 °F) or more
633 7
Control command for engine fuel
actuator 1
Pressure limiter emergency opening • Sensor supply voltage VCC# is normal
157 0
Engine Injector measuring tube 1
Pressure Actual pressure exceeds the
command pressure • Rail pressure sensor is normal
• Sensor supply voltage VCC# is normal
1347 7
Engine Fuel Pump Pressurizing
Assembly #1
SCV stuck at open position (Actual
rail pressure continuously exceeds
the command rail pressure)
• Engine is operating (Q: 3 mm3/st or more)
• Injector is normal
• Battery voltage is normal
• Sensor supply voltage VCC# is normal
• Rail pressure sensor is normal
1239 1 Engine Fuel Leakage 1
Fuel leak from high pressured fuel
system (Fuel consumption is
calculated from the difference of fuel
pressure of before and after the
injection, and the error will be
detected when excess fuel
consumption is found)
• Battery voltage is normal
• Sensor supply voltage VCC# is normal
• Rail pressure sensor is normal
• Supply pump (SCV) is normal
• Injector and injector drive circuit are normal
• NE signal is active [Engine is operating (700 rpm or
more)]
• No DTC of P0087, P0088, P0089
172 4 Engine Air Inlet Temperature
Ground short circuit of sensor or
harness
Battery voltage is normal
172 3 Engine Air Inlet Temperature
Open circuit or +B short circuit of
sensor or harness
Battery voltage is normal
110 4 Engine Coolant Temperature
Ground short circuit of sensor or
harness
Battery voltage is normal
110 3 Engine Coolant Temperature
Open circuit or +B short circuit of
sensor or harness
Battery voltage is normal
157 4
Engine Injector Metering Rail 1
Pressure Ground short circuit of sensor or
harness Failure of sensor • Battery voltage is normal
• Sensor supply voltage VCC# is normal
157 3
Engine Injector Metering Rail 1
Pressure Open circuit or +B short circuit of
sensor or harness Failure of sensor • Battery voltage is normal
• Sensor supply voltage VCC# is normal
523535 0 Proprietary Injector charge voltage: High
• Battery voltage is normal
• CPU is normal
651 3 Engine Injector Cylinder #01
Open circuit of harness Open circuit
of injector coil
• Engine is operating
• Battery voltage is normal
• During injection
• CPU is normal
653 3 Engine Injector Cylinder #03
Open circuit of harness Open circuit
of injector coil
• Engine is operating
• Battery voltage is normal
• During injection
• CPU is normal
654 3 Engine Injector Cylinder #04
Open circuit of harness Open circuit
of injector coil
• Engine is operating
• Battery voltage is normal
• During injection
• CPU is normal
652 3 Engine Injector Cylinder #02
Open circuit of harness Open circuit
of injector coil
• Engine is operating
• Battery voltage is normal
• During injection
• CPU is normal
110 0 Engine Coolant Temperature
Overheat of engine coolant
temperature
Coolant temperature sensor is normal
190 0 Engine Speed
Engine speed exceeds threshold
speed
Key switch is ON
102 4 Engine Intake Manifold #1 Pressure
Ground short circuit of sensor or
harness Failure of sensor • Battery voltage is normal
• Sensor supply voltage VCC# is normal
102 3 Engine Intake Manifold #1 Pressure
Open circuit or +B short circuit of
sensor or harness Failure of sensor • Battery voltage is normal
• Sensor supply voltage VCC# is normal
636 8 Engine Position Sensor
Open circuit or short circuit of sensor
or harness Failure of sensor
• Battery voltage is normal
• Sensor supply voltage VCC# is normal
• Engine is not stalled