Eurotrac T13-F, Operation Manual

Page: 49 / 81

Page 49/81
April 2021 W11 - W12S -W12F - W13F - T13F | Operation manual
4.5 Trailer procedure
If the loader requires assistance, allow towing only for short distances. However, observe the following steps before
towing the loader.
WARNING
With the loader towed, the brakes and steering do not function properly. The tractor must have sufficient tractive
force to pull and steer the loader without a brake system. Only use a drawbar as a connection to the towing
machine.
After repairing, check the brake function.
NOTE
The focus point of the machine salvage can be the vehicle lifting point (see Annex 3), the traction point when
dragged is in the back of counterweight. Allowed maximum force points value: 20KN.
This machine can be used for short-drag powerless trailer:
1.
The location of Traction is at the rear of counterweight.
2. The maximum traction value of this machine is:
W11: 7.5KN
W12S: 10KN
W13F/T13F: 20KN
3. Maximum traction speed is 5 km/h.
4. Only allows rigid drawbar traction.
5. Not for long traction.
6. When used as a tractor, please pay close attention to the hydraulic oil temperature, can’t exceed the maximum
temperature of piston pump.
Trailer steps
Place the skid (wedge) behind the sliding edge of the wheel.
Lower the goods enough so that the load does not hit the ground during work.
Removing the goods and attachments.
Starting the tractor.
Connect the tractor (with sufficient traction and braking power) to a tow bar on the tow pin
located on the counterweight on the back of the loader.
Release hand brake Open the manual bypass valve on the plunger pump.
After traction
Use the wedge to wedge the wheel slip.
Tighten hand brake.
Restore the braking force
Tighten the manual bypass valve.
Install a seat mounting plate.